41
41
4TEX Drill
4TEX Drill faceplate chips
Faceplates: 4TEX® Drill 
Code:
2307
Share on Facebook    Share on Twitter    Share on LinkedIn    Email a friend
The Challenge

Enough is enough when it comes to tool failure. 

Nothing squanders an application’s productivity like tool failure. Not only is your tooling ruined, but chances are your part is scrapped too. While using a lathe to machine faceplates from 1045 steel, our customer experienced tool failure after about 250 parts. It wasn’t long before they were fed up and ready to find the right solution. 

Our customer tested the 4TEX Indexable Carbide Drill using the “M” geometry inserts with AM485 coating, which is designed to resist heat, and a higher rake geometry that provides excellent chip formation in stainless steels. The 4TEX performed better than our customer had hoped. Where the previous tooling failed after 250 parts, the 4TEX completed 300 parts with the first index. Our customer easily finished their current job before they even rotated the inserts. 

Using the 4TEX not only provided substantial tool life improvements, but it also improved cycle time. The previous tooling completed the process in 26 seconds, but the 4TEX lowered that time to 8 seconds (a 69% decrease). The 4TEX was offset in the X-axis in order to drill the non-standard diameter in one shot. This allowed our customer to remove a boring pass and save additional time in the process. 

All the tool failure frustrations ceased to exist once the 4TEX occupied the spindle. Tool life and cycle time both improved, proving that all you need is the right tool for the job. When enough is enough, it’s time to find a better solution. 

Find an Allied tooling distributor near you.
 

Product 4TEX Drill
Objectives (1) Increase tool life
(2) Eliminate tool failure
Industry Military/Defense
Part Faceplate
Material 1045 steel
Hole Ø 0.717"
Hole Depth 0.650"

 
The Solution
4TEX Indexable Carbide Insert Drill
  • Drill holder, 2xD length:  D2051800M-100F
  • Drill inserts, M geometry (stainless steel & high temp):  4T-05T203-M

Measure Competitor IC Drill 4TEX Drill
RPM 500 2000
Speed Rate 94 SFM 375 SFM
Feed Rate 0.003 IPR 0.0025 IPR
Penetration Rate 1.5 IPM 5 IPM
Cycle Time 26 sec 8 sec
Tool Failure Yes No

 
The Advantages
The 4-sided indexable inserts with heat-resistant coating provided:
  • Lathe offset to drill non-standard diameter
  • Decreased cycle time
  • Increased tool life
  • Worry-free machining